/* * CDDL HEADER START * * The contents of this file are subject to the terms of the * Common Development and Distribution License (the "License"). * You may not use this file except in compliance with the License. * * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE * or http://www.opensolaris.org/os/licensing. * See the License for the specific language governing permissions * and limitations under the License. * * When distributing Covered Code, include this CDDL HEADER in each * file and include the License file at usr/src/OPENSOLARIS.LICENSE. * If applicable, add the following below this CDDL HEADER, with the * fields enclosed by brackets "[]" replaced with your own identifying * information: Portions Copyright [yyyy] [name of copyright owner] * * CDDL HEADER END */ /* * Copyright 2009 Sun Microsystems, Inc. All rights reserved. * Use is subject to license terms. */ #ifndef _SYS_DDI_INTR_H #define _SYS_DDI_INTR_H /* * Sun DDI interrupt support definitions */ #include #include | #include #ifdef __cplusplus extern "C" { #endif #ifdef _KERNEL /* * Interrupt related definitions. */ /* * Returned by ddi_add_intr or ddi_add_fastintr in order to signal * the the caller requested interrupt number to be added does not * exist. */ #define DDI_INTR_NOTFOUND 1 /* interrupt not found error */ /* * For use by driver interrupt service routines to return to the * system whether an interrupt was for the driver or not. */ #define DDI_INTR_CLAIMED 1 /* returned when driver claims intr */ #define DDI_INTR_UNCLAIMED 0 /* returned when driver does not */ /* Hardware interrupt types */ #define DDI_INTR_TYPE_FIXED 0x1 #define DDI_INTR_TYPE_MSI 0x2 #define DDI_INTR_TYPE_MSIX 0x4 /* Hardware interrupt priority must be a number within these min/max values */ #define DDI_INTR_PRI_MIN 1 #define DDI_INTR_PRI_MAX 12 /* Soft priority must be a number within these min/max values */ #define DDI_INTR_SOFTPRI_MIN 1 #define DDI_INTR_SOFTPRI_MAX 9 /* Used in calls to allocate soft interrupt priority. */ #define DDI_INTR_SOFTPRI_DEFAULT DDI_INTR_SOFTPRI_MIN /* * Interrupt flags specify certain capabilities for a given * interrupt (by type and inum). * RO/RW refer to use by ddi_intr_set_cap(9f) * * DDI_INTR_FLAG_MSI64 is an internal flag not exposed to leaf drivers. */ #define DDI_INTR_FLAG_LEVEL 0x0001 /* (RW) level trigger */ #define DDI_INTR_FLAG_EDGE 0x0002 /* (RW) edge triggered */ #define DDI_INTR_FLAG_MASKABLE 0x0010 /* (RO) maskable */ #define DDI_INTR_FLAG_PENDING 0x0020 /* (RO) int pending supported */ #define DDI_INTR_FLAG_BLOCK 0x0100 /* (RO) requires block enable */ | #define DDI_INTR_FLAG_MSI64 0x0200 /* (RO) MSI/X supports 64 bit addr */ | #define DDI_INTR_FLAG_RETARGETABLE 0x0400 /* (RO) retargetable */ /* * Macro to be used while passing interrupt priority * for lock initialization. */ #define DDI_INTR_PRI(pri) (void *)((uintptr_t)(pri)) /* * Typedef for interrupt handles */ typedef struct __ddi_intr_handle *ddi_intr_handle_t; typedef struct __ddi_softint_handle *ddi_softint_handle_t; /* | * Typedef for interrupt target | */ | typedef processorid_t ddi_intr_target_t; | | /* * Definition for behavior flag which is used with ddi_intr_alloc(9f). */ #define DDI_INTR_ALLOC_NORMAL 0 /* Non-strict alloc */ #define DDI_INTR_ALLOC_STRICT 1 /* Strict allocation */ /* * Typedef for driver's interrupt handler */ typedef uint_t (ddi_intr_handler_t)(caddr_t arg1, caddr_t arg2); #endif /* _KERNEL */ #include #ifdef _KERNEL /* * DDI interrupt function prototypes. * * New DDI interrupt interfaces. */ /* * ddi_intr_get_supported_types: * * Return, as a bit mask, the hardware interrupt types supported by * both the device and by the host in the integer pointed * to be the 'typesp' argument. */ int ddi_intr_get_supported_types(dev_info_t *dip, int *typesp); /* * ddi_intr_get_nintrs: * * Return as an integer in the integer pointed to by the argument * *nintrsp*, the number of interrupts the device supports for the * given interrupt type. */ int ddi_intr_get_nintrs(dev_info_t *dip, int type, int *nintrsp); /* * ddi_intr_get_navail: * * Return as an integer in the integer pointed to by the argument * *navailp*, the number of interrupts currently available for the * given interrupt type. */ int ddi_intr_get_navail(dev_info_t *dip, int type, int *navailp); /* * Interrupt resource allocate/free functions */ int ddi_intr_alloc(dev_info_t *dip, ddi_intr_handle_t *h_array, int type, int inum, int count, int *actualp, int behavior); int ddi_intr_free(ddi_intr_handle_t h); /* * Interrupt get/set capacity functions */ int ddi_intr_get_cap(ddi_intr_handle_t h, int *flagsp); int ddi_intr_set_cap(ddi_intr_handle_t h, int flags); /* * Interrupt priority management functions */ uint_t ddi_intr_get_hilevel_pri(void); int ddi_intr_get_pri(ddi_intr_handle_t h, uint_t *prip); int ddi_intr_set_pri(ddi_intr_handle_t h, uint_t pri); /* * Interrupt add/duplicate/remove functions */ int ddi_intr_add_handler(ddi_intr_handle_t h, ddi_intr_handler_t inthandler, void *arg1, void *arg2); int ddi_intr_dup_handler(ddi_intr_handle_t org, int vector, ddi_intr_handle_t *dup); int ddi_intr_remove_handler(ddi_intr_handle_t h); /* | * Interrupt get/set affinity functions | */ | int ddi_intr_get_affinity(ddi_intr_handle_t h, ddi_intr_target_t *tgt_p); | int ddi_intr_set_affinity(ddi_intr_handle_t h, ddi_intr_target_t tgt); | | /* * Interrupt enable/disable/block_enable/block_disable functions */ int ddi_intr_enable(ddi_intr_handle_t h); int ddi_intr_disable(ddi_intr_handle_t h); int ddi_intr_block_enable(ddi_intr_handle_t *h_array, int count); int ddi_intr_block_disable(ddi_intr_handle_t *h_array, int count); /* * Interrupt set/clr mask functions */ int ddi_intr_set_mask(ddi_intr_handle_t h); int ddi_intr_clr_mask(ddi_intr_handle_t h); /* * Interrupt get pending function */ int ddi_intr_get_pending(ddi_intr_handle_t h, int *pendingp); /* * Interrupt resource management function */ int ddi_intr_set_nreq(dev_info_t *dip, int nreq); /* * Soft interrupt functions */ int ddi_intr_add_softint(dev_info_t *dip, ddi_softint_handle_t *h, int soft_pri, ddi_intr_handler_t handler, void *arg1); int ddi_intr_remove_softint(ddi_softint_handle_t h); int ddi_intr_trigger_softint(ddi_softint_handle_t h, void *arg2); int ddi_intr_get_softint_pri(ddi_softint_handle_t h, uint_t *soft_prip); int ddi_intr_set_softint_pri(ddi_softint_handle_t h, uint_t soft_pri); /* * Old DDI interrupt interfaces. * * The following DDI interrupt interfaces are obsolete. * Use the above new DDI interrupt interfaces instead. */ /* * Return non-zero if the specified interrupt exists and the handler * will be restricted to using only certain functions because the * interrupt level is not blocked by the scheduler. I.e., it cannot * signal other threads. */ int ddi_intr_hilevel(dev_info_t *dip, uint_t inumber); int ddi_get_iblock_cookie(dev_info_t *dip, uint_t inumber, ddi_iblock_cookie_t *iblock_cookiep); /* * ddi_dev_nintrs * * If the device has h/w interrupt(s), report * how many of them that there are into resultp. * Return DDI_FAILURE if the device has no interrupts. */ int ddi_dev_nintrs(dev_info_t *dev, int *resultp); /* * ddi_add_intr: Add an interrupt to the system. * * The interrupt number "inumber" determines which interrupt will * be added. The interrupt number is associated with interrupt * information provided from self identifying devices or configuration * information for non-self identifying devices. If only one interrupt * is associated with the device then the interrupt number should be 0. * * If successful, "*iblock_cookiep" will contain information necessary * for initializing locks (mutex_init, cv_init, etc.) as well as for * possible later removal of the interrupt from the system. * * If successful, "*idevice_cookiep" will contain the correct programmable * device interrupt value (see in the form of the * type ddi_idevice_cookie_t). * * Either cookie pointer may be specified as a NULL pointer * in which case no value will be returned. * * The interrupt handler "int_handler" is the address of the routine * to be called upon receipt of an appropriate interrupt. The * interrupt handler should return DDI_INTR_CLAIMED if the * interrupt was claimed, else DDI_INTR_UNCLAIMED. The argument * "int_handler_arg" will be passed to the "int_handler" * upon receipt of an appropriate interrupt. * * If successful ddi_add_intr will return DDI_SUCCESS. * If the interrupt information cannot be found it will * return DDI_INTR_NOTFOUND. * */ int ddi_add_intr(dev_info_t *dip, uint_t inumber, ddi_iblock_cookie_t *iblock_cookiep, ddi_idevice_cookie_t *idevice_cookiep, uint_t (*int_handler)(caddr_t int_handler_arg), caddr_t int_handler_arg); /* * The following function is for Sun's internal use only at present */ int ddi_add_fastintr(dev_info_t *dip, uint_t inumber, ddi_iblock_cookie_t *iblock_cookiep, ddi_idevice_cookie_t *idevice_cookiep, uint_t (*hi_int_handler)(void)); /* * ddi_remove_intr: Remove interrupt set up by ddi_add_intr. * * This routine is intended to be used by drivers that are * preparing to unload themselves "detach" from the system. */ void ddi_remove_intr(dev_info_t *dip, uint_t inum, ddi_iblock_cookie_t iblock_cookie); /* * For use by ddi_add_softintr in order to specify a priority preference. */ #define DDI_SOFTINT_FIXED 0 /* Fixed priority soft interrupt */ #define DDI_SOFTINT_LOW 8 /* Low priority soft interrupt */ #define DDI_SOFTINT_MED 128 /* Medium priority soft interrupt */ #define DDI_SOFTINT_HIGH 256 /* High priority soft interrupt */ int ddi_get_soft_iblock_cookie(dev_info_t *dip, int preference, ddi_iblock_cookie_t *iblock_cookiep); /* * ddi_add_softintr: Add a "soft" interrupt to the system. * * Like ddi_add_intr, only for system interrupts that you can trigger * yourself. You specify a preference (see above) for the level you * want. You get an identifier back which you can use to either trigger * a soft interrupt or, later, remove it. */ int ddi_add_softintr(dev_info_t *dip, int preference, ddi_softintr_t *idp, ddi_iblock_cookie_t *iblock_cookiep, ddi_idevice_cookie_t *idevice_cookiep, uint_t (*int_handler)(caddr_t int_handler_arg), caddr_t int_handler_arg); void ddi_remove_softintr(ddi_softintr_t id); void ddi_trigger_softintr(ddi_softintr_t id); #endif /* _KERNEL */ #ifdef __cplusplus } #endif #endif /* _SYS_DDI_INTR_H */